Author: Jakub Stachowicz
-
KH Keeper plus en
The latest product from Reef Factory that makes every marine aquarist’s life easier. Products from our KH keeper line meet the highest standards for measuring the KH value in marine aquariums. The smallest device in the KH keeper family Small dimensions, convenient management, full automation of measurements. The KH keeper will work wherever space is…
-
List of devices the Level sensor integrates with (actions)
List of devices the Level sensor integrates with (actions) Here is a list of devices with which the Level sensor can perform actions: Smart feeder Base pump Kh keeper Smart tester Ph meter Dosing pump Power switcher Depending on the water level, you can control these devices. You can turn them on or off, and…
-
Examples of Using a Level Sensor in a Marine Aquarium
Examples of Using a Level Sensor in a Marine Aquarium A Level Sensor, which is a device for detecting liquid levels, can play an important role in managing marine aquariums. It allows for the automation of many processes and provides greater control over the conditions in the aquarium. Its use not only makes daily aquarium…
-
Smart tester errors and events
Errors and events during measurement #error100 #error110 #error111 #error112 #error113 #error120 #error121 #error122 #error123 #error124 #error210 #error 211 #error212 #error213 #error300 #error321 #error322 #error323 #error410 #error411 #error412 #error413 #error424 Errors & events during calibration of the measurement couvette Errors & events during checking of calibration of the measurement couvette (1) Errors & events during checking…
-
Pulling out the dropper head in the Smart tester
In this article, the correct method of pulling out the reagent pump head will be presented 2. Take out the measuring cuvette 3. Pull the dripper out of the holder and remove it to pull out the hose. Grasp the head and carefully pull it out a few millimetres so that the hose can be…
-
Adjustment of rubber bands in the dropper head pump
This article will show the correct method for adjusting the rubber bands on the dropper pump 2. Measure the distance between the two blue rubber bands. If it is more than 40 mm, it should be corrected to such a distance. 3. After correcting the distance between the bands to exactly 40 mm, assemble the…
-
How to prepare a Reef Flare for shipping 📦
This article will show the correct method of preparing and packing the device for delivery to the Reef Factory service center. ⚠️ Inadequate protection of the device for transport may be the basis for the loss of the device warrantyand denial of service repair! 2. Put everything in the original carton. If you don’t have…
-
How to prepare a TDS meter for shipping 📦
This article will show the correct method of preparing and packing the device for delivery to the Reef Factory service center. ⚠️ Inadequate protection of the device for transport may be the basis for the loss of the device warrantyand denial of service repair! 2. Put everything in the original carton. If you don’t have…
-
How to prepare a Smart tester for shipping 📦
In this article you will learn how to properly prepare the Smart tester device for shipment so that it is safe for the device. ⚠️ CAUTION: When touching the reagent cartridges, the measuring cuvette, and other items in contact with the reagents, maintain personal protective equipment according to the label on the cartridge package or…